Robotics

1.Installation of Robot.
 

Challenge #1
      Challenge number 1 was a bit complicated due to having the exact coordination to were the robot was going to run too. but in the end the challenge was completed and we managed to get the robot to the coordination needed.

Challenge #2
       In Challenge number 2 we had to keep the robot maintain itself in the box and Whenever it detected the black line the robot we move away from it. This challenge was a bit hard but we were given the code to do this challenge. So it was pretty simple.

Challenge#3
    In this Challenge our assignment is to get the robot to follow the black line. This challenge is harder because we have to figure out the code to have the robot move in a straight line following the black line. We have to do this based on challenge #2 code they are fairly similar.

Challenge#4
   In this challenge the assignment was wall detection. The robot was supposed to detect the wall and move away from it. It was a fairly simple challenge. We were given the code and see if we had plugged in the right code to the robot. We were successful and completed this challenge.

Challenge#5
   In challenge number 5 we have to put together challenge #3 and #4 to have the robot detect the wall and the black line.

Challenge#6
   In this challenge our assignment is to get the robot to move using sounds. The louder the noise the faster the robot goes. As the robot goes slower is there is low noise or dose not move at all when the robot dose no detect any noise.

Challenge#7
   In challenge 7  our objective data rocorder (variable). In this challenge we had to get the robot to detect the black line as well as wall detection and noise detector. Once the robot heard noise from inside the box. The robot had to move backwards and show a number variable.

Challenge#8
     In challenge 8 the objective was counting lines. The robots goal was to run forward while counting the black lines. Once the robot finished counting the robot will dance. By spinning in circles. This challenge was a bit complicated to figure out but we were given most of the code which made it much easier.

Challenge#9
     In challenge 9 the objective  was to detect an object infront of it and stop moving forward and begin to move back slowly while showing a variable on the screen. This challenge was difficult becouse we wernt quite sure how to make it move back and stoping. We finally got help and we were able to complete the challenge.